News Center
News Center
Image Name

NEWS

News Center

10-31

2018

Common Principles and Structures of Condensers

The condenser is one of the key components in a refrigeration system. It transfers the heat from the superheated refrigerant vapor to the surrounding air or water via its heat‑releasing surface, thereby cooling itself into saturated vapor and further condensing into a high‑pressure liquid, which then circulates within the system. The following section describes the operating principles and construction of common types of condensers. 1. Horizontal shell-and-tube condenser: Refrigerant vapor condenses on the outer surfaces of the tubes, while cooling water flows inside the tubes under the action of a pump. The refrigerant vapor enters through the upper inlet pipe and, after condensing into a liquid, exits via the lower outlet pipe at the bottom of the shell and flows into the receiver. The ends of the condenser shell are sealed with end caps, and these caps incorporate water‑distribution baffles.


12-17

2018

How do you adjust a thermostatic expansion valve? How should ice blockages or dirt blockages be handled?

The expansion valve is one of the four major components of a refrigeration system. It is a critical device for regulating and controlling the flow and pressure of the refrigerant as it enters the evaporator, and it also serves as the boundary between the high-pressure and low-pressure sides. Its adjustment not only determines whether the entire refrigeration system can operate properly but also serves as an important indicator of the operator’s skill level. Adjusting the expansion valve must be carried out carefully and patiently. The pressure change resulting from the adjustment becomes apparent on the pressure gauge only after the refrigerant has undergone heat exchange and vaporization in the evaporator, with the vapor then flowing through the piping into the compressor’s suction chamber—a process that takes time. Each time the expansion valve is adjusted, it typically requires 15 to 30 minutes for the changes to stabilize.


12-01

2019

Working principle of a falling-film evaporator

The main body of a falling-film evaporator consists of numerous components, such as a thermal compression pump, a separator, insulated piping, a water pump, and an instrument cabinet. Each of these pieces of equipment has its own distinct characteristics and applications; among them, any component that comes into direct contact with the process material…


< 1234 >
< 1234 >